Skip to content

Driver Power Window Down Circuit Open

Jump to the fix

Severity

Medium

Can I keep driving?

Usually drivable, but get it diagnosed without delay.

First step

Read all restraint codes and note whether the fault is current or historic

  • BBody
  • 1Manufacturer-specific
  • 4Body
  • 04Sequence number

What does it mean?

B1404 is a Body (airbags, seat belts, body electronics) fault code. It indicates: Passenger Front Side Impact Sensor (FSIS) Circuit Short To Ground .

Symptoms

  • SRS lamp on with the passenger side and curtain airbags disabled
  • The fault may set when the passenger door is slammed or over rough roads if the short is intermittent
  • Other passenger side restraint codes may be stored at the same time
  • The code returns immediately after clearing while the short is solid
  • No effect on engine operation or driveability

Likely causes

  • Sensor wiring chafed against the passenger door inner panel, a bracket or the B-pillar structure
  • Water inside the passenger door after the vapour barrier or a window seal failed, tracking to ground at the connector
  • Broken and grounded conductor in the passenger door harness inside the rubber hinge boot
  • Sensor connector damaged or a terminal backed out and touching the sensor bracket
  • Sensor shorted internally to its own housing
  • Loom trapped and crushed during door trim, speaker or window regulator work
  • Airbag control module input fault

How to fix it

  1. Read all restraint codes and note whether the fault is current or historic
  2. Power the system down safely, disconnect the battery and wait the specified reserve power discharge time
  3. With the sensor and the module connector both unplugged, measure the sensor circuit to body ground; a low reading confirms a shorted harness
  4. If the harness is clean with both ends free, the short is inside the sensor or the control module
  5. Inspect the harness inside the door hinge boot and behind the door trim for bare copper and crush damage
  6. Dry out the door and fix the water leak, then repair the wiring with approved restraint repair parts
  7. Replace the sensor if it is internally shorted, torque it to specification and confirm the lamp goes out after clearing

Codes From the Same System

All Fault Codes

Related Similar Codes

This information follows the generic OBD-II definition and does not replace a vehicle-specific diagnosis. The severity rating is rule-based; an authorised diagnostic reading is required for a definitive answer.