What does it mean?
P3462 is a Powertrain (engine, transmission, fuel system) fault code. It indicates: Cylinder 8 Exhaust Valve Control Circuit Performance . This is a standardised OBD-II code. The technical definition is the same regardless of the make or model of vehicle, although specific causes and symptoms can vary between vehicles.
Symptoms
- The MIL (check engine light) comes on and the module records the fault with a freeze frame.
- Ticking or knocking above cylinder 8 that changes with oil temperature and is loudest right after a cold start.
- A shudder, jerk or vibration every time the engine tries to enter or leave cylinder deactivation.
- Misfire at light cruise, which is exactly the operating range where deactivation is used.
- When the exhaust side does not switch as commanded, trapped combustion gas can cause popping in the intake or exhaust and unstable fuel trims.
- Higher fuel consumption once the module disables the deactivation function, plus a few seconds of rough running after start-up until oil pressure builds.
Likely causes
- Oil that is low, overdue or of the wrong viscosity, since the switching lifters are actuated by oil pressure and cannot latch reliably with poor oil.
- Blocked oil path to the cylinder 8 lifter, from varnish in the galleries, a neglected oil filter or a clogged screen behind the solenoid.
- Sticking solenoid spool caused by varnish or debris, so oil pressure reaches the lifter too slowly for the commanded switch.
- Worn or seized switching lifter/tappet on cylinder 8, with locking pins that no longer latch or release cleanly.
- Low oil pressure from a worn pump or a faulty oil pressure control solenoid, which starves the whole valve control system.
- Extra resistance in the control circuit from a corroded terminal, slowing the solenoid without setting an open or short code.
- Wear or damage on the exhaust-side cam lobe and lifter of cylinder 8, which carry the highest thermal and mechanical load in the valvetrain.
How to fix it
- Check the oil level, the oil condition and that the oil in the engine is the specified viscosity; an oil and filter service with the correct grade is a legitimate first step here, not a shortcut.
- Read the freeze frame and note the oil temperature, engine load and RPM at the moment the fault was set.
- Scan for oil pressure and variable valve timing codes, because a low oil pressure problem has to be corrected before this valve control fault can be judged.
- Command the solenoid with a scan tool output test and compare the commanded deactivation state with the actual state in live data.
- Measure the control circuit and solenoid resistance; a few extra ohms in a corroded terminal is enough to slow the actuator and set a performance code.
- Remove the solenoid and inspect it and its filter screen for debris, then clean or replace it as required.
- If the electrical side and the oil supply both check out, inspect the switching lifter and cam lobe on cylinder 8 mechanically; a collapsed lifter can damage the camshaft, so the fault should not be left unresolved.