What does it mean?
P3488 is a Powertrain (engine, transmission, fuel system) fault code. It indicates: Cylinder 11 Exhaust Valve Control Circuit High . This is a standardised OBD-II code. The technical definition is the same regardless of the make or model of vehicle, although specific causes and symptoms can vary between vehicles.
Symptoms
- The check engine light (MIL) is on and the code is stored together with freeze frame data.
- Cylinder deactivation is switched off, so the engine runs on all cylinders and fuel consumption rises noticeably in steady cruising.
- Vibration or shudder at light load, sometimes a misfire traced to cylinder 11.
- A valvetrain tick above cylinder 11 that comes and goes with engine temperature.
- When the exhaust side does not switch as commanded, trapped combustion gas can cause popping in the intake or exhaust and unstable fuel trims.
- The fault is often intermittent: it shows up once the engine warms through or on rough surfaces, and some vehicles reduce power while it is active.
Likely causes
- High-resistance or open connection in the control wire, so the module's monitoring circuit never sees the line pulled down.
- Corroded, loose or spread terminal in the solenoid connector: the classic reason a fault only appears once the engine is hot or over rough roads.
- Control wire chafed against a powered circuit and shorted to battery voltage.
- Open winding inside the solenoid, so no load is present on the output.
- Missing or high-resistance ground for the solenoid circuit, or a corroded module ground point.
- Heat ageing of the exhaust-side connector and its seal, which lets moisture in and raises contact resistance.
- Failed ECM output driver, considered only after the wiring, the grounds and the solenoid have all been verified.
How to fix it
- Read the freeze frame and note coolant/oil temperature, load and RPM; a fault that only appears hot points at a stretched terminal or a heat-damaged wire.
- Inspect the solenoid connector: check terminal tension against a new terminal, look for green corrosion, oil intrusion and a damaged seal.
- Backprobe the control line with a meter or a scope, key on, and watch what the voltage does when the output is commanded; a line stuck at battery voltage with the solenoid connected confirms the circuit fault.
- Measure the solenoid resistance and compare it with a neighbouring cylinder's unit, since an open winding reads infinite.
- With both the solenoid and the module connector unplugged, test the control wire for a short to voltage and for end-to-end continuity.
- Check the ground and supply side of the circuit, including the module ground points, and clean any corroded stud.
- Repair or reterminate the wiring, or replace the solenoid, depending on what the measurements show; replace the ECM only after its driver has been proven faulty with a known-good load.