Skip to content

LAMP DOME OUTPUT Circuit Short to Battery

Jump to the fix

Severity

Medium

Can I keep driving?

Usually drivable, but get it diagnosed without delay.

First step

Check the fuse and test whether it still blows with the left headlamp unplugged

  • BBody
  • 2Manufacturer-specific
  • 5Body
  • 55Sequence number

What does it mean?

B2555 is a Body (airbags, seat belts, body electronics) fault code. It indicates: Left Headlamp (Low Beam) Short to Ground .

Symptoms

  • Left low beam does not light, with the fuse often blown
  • Both low beams may go out together once the module protects the shared output
  • Lighting failure message on the instrument cluster
  • Light comes on briefly at switch-on and then goes out
  • Fault appears or worsens after rain, snow or a wash
  • Discoloured or melted connector visible at the left headlamp

Likely causes

  • Internally shorted low beam bulb or a socket contact bent onto the metal shell
  • Corrosion inside the left headlamp connector after water or washer fluid has entered
  • Chafed feed wire against the battery tray, air box bracket or inner fender edge
  • Cracked lamp housing or a missing rear cap seal letting moisture reach the bulb terminals
  • Failed ballast or LED driver on discharge and LED equipped lamps
  • Wiring damaged during previous work on the front end and taped rather than repaired
  • Shorted output driver in the lighting control module

How to fix it

  1. Check the fuse and test whether it still blows with the left headlamp unplugged
  2. Examine the left headlamp connector and socket for burnt pins, corrosion and moisture
  3. Measure resistance from the low beam feed to ground on the harness side with the lamp disconnected
  4. On discharge or LED lamps, disconnect the ballast or driver module to see whether the short lies inside the assembly
  5. Inspect the harness along the battery tray and inner fender, flexing it while monitoring the meter
  6. Repair the damaged wiring with a sealed splice, reroute it away from sharp edges and reseal any grommet
  7. Once the circuit is clean, command the output with a scan tool and evaluate the module only if the fault persists

Codes From the Same System

All Fault Codes

Related Similar Codes

This information follows the generic OBD-II definition and does not replace a vehicle-specific diagnosis. The severity rating is rule-based; an authorised diagnostic reading is required for a definitive answer.