Skip to content

Left Lamp Outage Signal Circuit Short to Ground

Jump to the fix

Severity

Medium

Can I keep driving?

Usually drivable, but get it diagnosed without delay.

First step

Check the park lamp fuse and note whether the dashboard lighting is affected at the same time

  • BBody
  • 2Manufacturer-specific
  • 5Body
  • 71Sequence number

What does it mean?

B2571 is a Body (airbags, seat belts, body electronics) fault code. It indicates: Right Park Lamp Short to Ground .

Symptoms

  • Right park or position light does not illuminate with the lights switched on
  • Fuse for the park lamps blows, often killing the dashboard illumination as well
  • Left side position lamps work normally, showing the fault is side specific
  • Lamp outage warning in the cluster and reduced visibility of the car at night
  • Lights work for a moment then go out as the module protects itself
  • Problem worsens after rain or a car wash

Likely causes

  • Corroded park lamp socket in the front or rear right lamp housing
  • Water inside the lamp assembly reaching the bulb contacts
  • Feed wire chafed against a bracket, body seam or wheel arch liner on the right side
  • Wrong bulb type fitted, or a bulb pushed in far enough for the base to touch the shell
  • Trailer, roof light or accessory wiring spliced into the park lamp circuit and shorting when wet
  • Number plate or marker lamps that share this circuit shorting internally
  • Failed lamp output driver in the body control module

How to fix it

  1. Check the park lamp fuse and note whether the dashboard lighting is affected at the same time
  2. Unplug the right front and right rear position lamps one at a time to isolate which branch causes the short
  3. Inspect each socket for corrosion, water and a contact touching the metal shell
  4. Measure resistance from the park lamp feed to ground with the lamps disconnected
  5. Include the number plate and marker lamps in the check, since they often share this output
  6. Remove any accessory wiring spliced into the circuit and retest with the factory harness alone
  7. Repair the shorted wire or socket, clear the code and confirm all position lamps on that side operate

Codes From the Same System

All Fault Codes

Related Similar Codes

This information follows the generic OBD-II definition and does not replace a vehicle-specific diagnosis. The severity rating is rule-based; an authorised diagnostic reading is required for a definitive answer.