What does it mean?
As we know, the modern fuel injection and ignition system is a complex coordination of sensor readings and actuator outputs, all with the aim of delivering the most efficient power. The engine control module (ECM) uses various sensors to determine how much fuel to inject at any given moment, making precise calculations based on air flow and temperature, engine load and speed, driver demand, and a number of others.
Because the density of the fuel depends on its temperature, the ECM needs to take this into account when calculating fuel injector pulse. Without knowing fuel temperature, the ECM would command the same fuel delivery at all temperatures, resulting in richer or leaner combustion than ideal. On engines equipped with a fuel temperature sensor (FTS), this results in finer control of air-fuel ratio and lower emissions.
Earlier vehicles not equipped with an FTS achieved similar results using feedback from the AFR sensors. The ECM continually monitors the resistance of the FTS, calculating temperature based on those readings. If there is a fault in the FTS or FTS circuit, the ECM will illuminate the malfunction indicator lamp (MIL) and set a diagnostic trouble code (DTC) in memory. When P0185 is set, the PCM has determined that there is a problem in the fuel temperature circuit.
Sensor B indicates that this vehicle has two fuel temperature sensors, and that the “B” sensor has the malfunction. Note: “Circuit Malfunction” indicates that there is a malfunction in the control circuit, as opposed to a fault in a sensor or other component. With “Circuit Malfunction” codes, replacement of sensors and components in the affected circuit will almost never resolve the problem, since as the code suggests, the trouble is in the circuit .
This distinction between “circuit” and “sensor/component” is a great help to anyone trying to diagnose a circuit malfunction code, since it narrows the list of possible causes down considerably.
The causes of “Circuit Malfunction” codes are much the same as those for “Open Circuits” i.e., broken wiring, poor connections across electrical connectors or previously repaired wiring, loss of ground that prevents current flow, blown fuses, defective relays, faulty switches, or any of a host of other issues and problems that prevents a flow of current through wiring. Issues like high/low/intermittent voltages can set a “Circuit Malfunction” code on some applications.
Moreover, “Circuit Malfunction” codes could also indicate a problem with negative current control / flow, as well as issues with failed or failing PCM’s (Powertrain Control Modules), although control module failure is a rare event.