What does it mean?
As we know, the modern fuel injection and ignition system is a complex coordination of sensor readings and actuator outputs, all with the aim of delivering the most efficient power. The engine control module (ECM) uses various sensors to determine how much fuel to inject at any given moment, making precise calculations based on air flow and temperature, engine load and speed, driver demand, and a number of others.
Because the density of the fuel depends on its temperature, the ECM needs to take this into account when calculating fuel injector pulse. Without knowing fuel temperature, the ECM would command the same fuel delivery at all temperatures, resulting in richer or leaner combustion than ideal. On engines equipped with a fuel temperature sensor (FTS), this results in finer control of air-fuel ratio and lower emissions.
Earlier vehicles not equipped with an FTS achieved similar results using feedback from the AFR sensors. The ECM continually monitors the resistance of the FTS, calculating temperature based on those readings. If there is a fault in the FTS or FTS circuit, the ECM will illuminate the malfunction indicator lamp (MIL) and set a diagnostic trouble code (DTC) in memory.
When P0188 is set, the PCM has determined that the input voltage from fuel temp sensor B is higher than the calibrated limit indicating a lower than normal temperature. Note: Circuit High Input codes are mostly caused by defective alternators that develop excessive voltages, although there may be other causes as well, such as short circuits that “leak” current into a particular system from other, unrelated systems that work on higher voltages.
Note that in the case of short circuits that leak power into a control circuit, there is likely to be other, seemingly unrelated trouble codes present along with the code(s) being investigated. Diagnosing a “high input” code will always involve a thorough testing of the charging system as a first step, followed by measures to isolate the system from all other possible sources of power during resistance, continuity, and reference voltage tests.