What does it mean?
As we know, the modern fuel injection and ignition system is a complex coordination of sensor readings and actuator outputs, all with the aim of delivering the most efficient power. The engine control module (ECM) uses various sensors to determine how much fuel to inject at any given moment, making precise calculations based on air flow and temperature, engine load and speed, driver demand, and a number of others.
Because the density of the fuel depends on its temperature, the ECM needs to take this into account when calculating fuel injector pulse. Without knowing fuel temperature, the ECM would command the same fuel delivery at all temperatures, resulting in richer or leaner combustion than ideal. On engines equipped with a fuel temperature sensor (FTS), this results in finer control of air-fuel ratio and lower emissions.
Earlier vehicles not equipped with an FTS achieved similar results using feedback from the AFR sensors. The ECM continually monitors the resistance of the FTS, calculating temperature based on those readings. If there is a fault in the FTS or FTS circuit, the ECM will illuminate the malfunction indicator lamp (MIL) and set a diagnostic trouble code (DTC) in memory.
When P0187 is set, the PCM has determined that the input voltage from fuel temp sensor B is lower than the calibrated limit indicating a higher than normal temperature. Note: Circuit Low Input codes are often the result of low battery voltages (that can have many possible causes), bad connections across electrical connectors or previously repaired wiring, as well as corrosion in electrical connectors.
Other possible causes of low input voltages include poor installation of aftermarket components, poor quality aftermarket components like fuses, relays, and switches, and modification of the electrical system that could include the use of conductors that are not rated for use in a particular application. However, poor connections often result in high resistances in some parts of the circuit, which is why it is important to perform resistance and continuity checks during the diagnostic procedure.