Skip to content

Blower Control Circuit Failure

Jump to the fix

Severity

Medium

Can I keep driving?

Usually drivable, but get it diagnosed without delay.

First step

Look at both fog lamps from underneath for cracked lenses, missing seals, water inside or crash damage

  • BBody
  • 2Manufacturer-specific
  • 5Body
  • 16Sequence number

What does it mean?

B2516 is a Body (airbags, seat belts, body electronics) fault code. It indicates: Front Fog Lamp Circuit Short to Ground .

Symptoms

  • Fog lamps do not come on, or only one side lights
  • Fog lamp fuse blows as soon as the switch is pressed
  • Fog lamp indicator on the dash lights but no light output at the bumper
  • Fault appears after driving in rain, snow or through deep water
  • Fog lamps flicker and then shut off permanently until the ignition is cycled
  • Other lighting on the same fused feed may drop out at the same time

Likely causes

  • Water, slush and road salt entering the fog lamp housing or connector and bridging the feed to the body
  • Cracked or stone-chipped fog lamp lens letting water reach the bulb socket
  • Wiring behind the bumper rubbed through against a bracket, or torn after a kerb or parking impact
  • Corroded, green-crusted terminals in the fog lamp pigtail
  • Shorted bulb or a failed LED fog module
  • Damaged fog lamp relay or a shorted control wire between the relay and the lamps
  • Retrofitted fog lamp kit wired without a fuse or a proper ground

How to fix it

  1. Look at both fog lamps from underneath for cracked lenses, missing seals, water inside or crash damage
  2. Check the fog lamp fuse and note whether it blows with the lamps unplugged, which separates lamp from harness
  3. Unplug each fog lamp and measure resistance from the feed wire to ground to find the shorted side
  4. Inspect the pigtails and connector pins for corrosion and clean or replace them rather than just adding grease
  5. Check the bumper harness routing for rub points and repair the insulation with sealed splices
  6. Swap or test the fog lamp relay and check its control wire for a short to ground
  7. Replace the fog lamp assembly if water damage is internal, then clear the code and test with the lights on

Codes From the Same System

All Fault Codes

Related Similar Codes

This information follows the generic OBD-II definition and does not replace a vehicle-specific diagnosis. The severity rating is rule-based; an authorised diagnostic reading is required for a definitive answer.